ePrivacy and GPDR Cookie Consent by Cookie Consent
              Call  01706 813393
Are you struggling to find what you are looking for ? We are here and always happy to help via email, phone or live chat !
Last Order date for all orders delivery before Christmas is Sunday 15th December 2024 - So please ensure all your orders placed on or before that date.

Firebelly FB2 Boiler Stove - 8kw

OUR PRICE

£3,488.20

 FB2Boil
 
   

Product Description

The Firebelly FB2 is available with an 8kW (27,000 btu) stainless steel boiler to be used for central heating and/or domestic hot water. The boiler can be retro fitted
to existing FB2 stoves if required

Open vented system
If using the FB2 boiler as the single source for water heating then it must be connected to an open vented system. A simplified example of an open vented
central heating circuit is shown (same principles apply for domestic hot water). The tank allows for the water in the system to expand when it is heated so that any
excess hot water entering the tank from the vent pipe is recovered. The tank is fitted with a ball cock which allows the mains cold water feed to top up the system
if there is any loss of water due to evaporation over time. There should also be an overflow fitted to the tank but this should be set fairly high so that the
normal rising of the water level in the tank as the system heats up does not cause hot water to be drained.

Heat dissipation
An electrical power cut would put any pump or motorised valve out of action. The heating circuit should be designed so that hot water can still rise by
gravity to either a heat sink radiator (minimum 3kW) or domestic hot water tank. Note: modern domestic hot water tanks are well insulated and so may not be able to dissipate heat once the water in the tank reaches temperature - a heat
sink radiator may still be required.

Connections
Rear view of the stove showing the position of the 1" BSP connections.
Using alongside another boiler The FB2 boiler can be used in partnership with
another boiler, for example an existing oil or gas fired boiler, with the aid of a neutraliser. The neutraliser
enables each boiler to operate independently without one affecting the performance of the other. It may be
tempting to connect both boilers in series with each other but this may produce unpredictable and
dangerous results and is against building regulations


Important points
Domestic hot water must be heated via an indirect system.
On a pumped system a pipe thermostat should be used on the flow of the boiler close to the stove. This should be set so that the pump
activates only when the water in the boiler reaches a temperature of 70C. This is to prevent cold water flowing through the stove as this
cools the firebox reducing combustion efficiencies and resulting in excessive tar formation.
The flow and return connections should be a minimum 22mm.
The stove must be level and any reduction in pipe size made on a rising pipe to prevent air trapping.
The boiler must not be used on a pressurized system.
The boiler must not be run dry.
Primary gravity/ pumped secondary - it must be possible for heat to be dissipated by gravity in the event of a
pumped system failure.
System design and installation should be carried out by a qualified plumber.


Please select next action

Go back ( or ) Go to wish list